![]() A Tool Change Macro program will be called by either M6 or by a T code. Try executing a Tool Change and see if a program number as described above is obvious.Ģ. The Macro Program number will be displayed at the Top Right corner of the screen, on late model controls, whilst the Macro program is executing. When a User Macro program is used by a Fanuc program:ġ. Of course, User Macro programming is an option, but is common on most machines nowadays. If you can determine if a User Macro program is involved, you should be able to determine the sequence of the Tool Change. This is not always the case its possible for the whole tool change to be completed by the PLC program. If its a clone of Fanuc, often, machines equipped with a Fanuc control have a User Macro program for the Tool Change. ![]() ![]() Thanks for all your suggestions to date all I cant seem to get a tool change sequence in either mdi or program mode, I will not get any sleep until I can get this sorted Lol I am trying to do a manual tool change in mdi, I can bring up tool page which lists all the tools & I have manually entered carousel position for them, but again I can not seem to get the machine to go & retentive or for that matter do anything from the tool page or if I program from mdi, I am stumped, the controller is basically a clone of the Fanuc I have been told.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |